atl_sod – posted 06 October 2010 09:00
I’m planning on plugging 3″ squares of zoysia in my current lawn that is fescue/weeds. I was thinking about spacing the plugs 10″-12″ apart. I’m looking to do this next May/June.
I was not planning on removing the existing fescue/weeds. I saw there is a 3″ plugging tool. Steps are to remove plug, sprinkle some compost and starter fertilizer to the hole and fill with plug. Do you foresee any problems? Any advice for a first time plugger?
I have a fairly large front and back yard so I can’t afford to sod the entire property. I don’t mind waiting for the zoysia to fill in as long as my process will work.
Thanks!
annahouston – posted 30 May 2011 08:23
I have to find grass that I can grow in my back yard. I have two huge oak trees,(shade), and two big dogs. I am going to fence of the yard in sections to allow the seeded and newly plugged area. The grass I choose needs to grow in shade, be able to put up with dog excrements until I hose it and pick it up. And my soil is hard, I have no idea what kind of soil to use to mix into the hard soil.
Houndawg – posted 01 February 2012 22:09
I changed an area over to Yosia last May. It was Centipede. My neighbor came over with his tractor and plowed the whole thing up. I was going to wait and kill off all grass that was out there, but the plowing killed almost all of it. I found that sprigging the grass in worked best for me. After the area was leveled, I dug trenches about a foot apart. And about a half inch to an inch deep. I dug up shovels of the grass ,using my shovel to make a round pug the size of the shovel pressed down, then lifted the plug out. I took the large plug to a small kiddy pool and using my water hose washed the dirt out of the plug. Use a jet nozzle. Once all dirt was removed , I pulled out the grass and placed it in a water bucket until it was pulled apart. I placed the grass sprigs in the trenches flat roots and all and covered them up. If there were and green leaves I’d leave some of them showing. I went down the trenches laying the grass end on end. Firming the dirt back with my hands. I watered just enough to wet the areas. I did not soak it 30 minutes as others say. I wet the area went it looked dry. In the morning , and again just before nightfall. I’d wet it around noon, if it was hot. In about two weeks the grass was growing. It takes a long time to do this, but by September I had a wonderful start on a new lawn.
Houndawg – posted 01 February 2012 22:19
I put 10-10-10 on the area after the grass was growing. I filled my Scotts hand spreder twice and covered the area, about 1000 square feet. Then I waited, if it was not a nice green I put a little more and stopped. Then a month or two later I gave it some more. By September the runners were everywhere, and rows touching and some crossing.
Houndawg – posted 01 February 2012 22:32
You have to patrol the area pulling any other grass out. Make sure no Bermuda gets in there..
Houndawg – posted 01 February 2012 22:41
I must be honest, I used about 40 large plugs. The grass I tried planting with roots down into the hole did not do as well. Just lay the srings down and the roots right against them, works lots better.
Houndawg – posted 01 February 2012 22:53
I never used a lawn sprinkler, I’d turn the water on full blast ,holding my finger over the end , and spray the water on. 5 or 10 mintues and go back in the house.
Houndawg – posted 01 February 2012 23:04
http://www.facebook.com/media/set/?set=a.315709615111350.96904.100000169413671&type=3&l=d77f03a98a